Special products.: OTC 1580 Stinger 1,500 lbs Easy Roller Dollybest

Customer Rating :

List Price : $189.95 Price : $115.13

Product Description

The Stinger Easy Roller provides a technician with a simple and efficient method of moving a disabled vehicle around a shop environment. Just position an Easy Roller at each wheel of a vehicle weighing up to 6,000 pounds, and use the foot pedals to activate the hydraulic lift mechanisms. Within minutes, one individual can easily move the car throughout the garage. The Easy Roller fits tread widths up to 12 inch, and the four heavy-duty phenolic casters can support up to 1,500 pounds per unit while, at the same time, protecting the shop floor from damage. Sold individually not as a pair.

Simple and efficient method of moving a disabled vehicle around a shop environment
Position an easy roller at each wheel of a vehicle weighing up to 6000 pounds and use the foot pedals to activate the hydraulic lift mechanisms
1,500 pounds capacity per unit with hydraulic lift mechanism with locking pin
Four heavy-duty phenolic casters and fits tread widths up to 12 inch
Sold individually not as a pair

OTC 1580 Stinger 1,500 lbs Easy Roller Dolly Reviews

5 of 6 people found the following review helpful

Works as expected, June 29, 2011

Lotus-Seven (The mountains of Illinois) - See all my reviews

Amazon Verified Purchase

This review is from: OTC 1580 Stinger 1,500 lbs Easy Roller Dolly (Tools & Home Improvement)

The Chinese-made OTC 1580 Stinger wheel jack dollies will quickly lift and move vehicles with up to 1500 lbs. per wheel loading. They're made of heavy gauge steel plate and square section tubing and the welds are good quality. The hydraulic ram seems to also be well made, but time will tell if the seals hold up. Leaking seals seem to be common on many low-cost imported jacks these days.
The casters are well made and swivel and roll easily when under load. The jack is easy to pump and it lifts the wheel with approximately 20 short strokes of the foot pedal. The dollies are heavy at around 40 lbs, each.

The only component of the OTC that is obviously "sub-par" is the control valve. It's a plastic knob on a plastic screw shaft, that feels "rubbery" when it's turned. It feels like it could easily break if tightened only a little too much or if opened too quickly. I'm looking into finding some brass replacements ASAP.

I tried the dollies on several... Read more

1 of 2 people found the following review helpful